> Training IPC/WHMA-A-620-CIS
Training IPC/WHMA-A-620-CIS
Requirements and acceptance for cable and wire harness assemblies
Training purpose
  • Gaining comprehensive knowledge necessary for wires and wire harnesses assembly according to IPC/WHMA-A-620 standard.

Training time length

  • Number of hours: program dependent

Training program

  • Chapter I - Introduction: generally used procedures and information about program, most important definitions.
  • Chapter II - Documents used in IPC/WHMA-A-620 standard.
  • Chapter III - Wires preparation.
  • Chapter IV - Solder ends.
  • Chapter V - Formed ends.
  • Chapter VI - Connection of isolated wires preventing from its displacement.
  • Chapter VII - Ultrasonic welding.
  • Chapter VIII - Braided connections.
  • Chapter IX - Connections of wire shields and protection sleeves.
  • Chapter X - Shaping/filling.
  • Chapter XI - Cable and wire connections.
  • Chapter XII - Marking/labelling.
  • Chapter XIII - Coaxial and twinaxial cable connections.
  • Chapter XIV - Wire harnesses protections.
  • Chapter XV - Electrical covering/shielding of wire and cable harnesses.
  • Chapter XVI - Protective layer for wire and cable harnesses.
  • Chapter XVII - Mechanical installation.
  • Chapter XVIII - Wire installation by coiling without soldering.
  • Chapters I and II are obligatory, the rest depending on customers requirements.

Training destined for persons

  • Directly involved in mounting and control of connections using wires and cables.

Advantages for participants

  • Gaining the newest knowledge about wires and cables assembly requirements according to current international standards.
  • Getting textbooks with didactic materials.
  • Receiving personal, international certificate of finishing IPC/WHMA-A-620 Certified IPC Specialist training.